Weekend Freedom Machines banner

18x8.50-8 on a 140

2K views 4 replies 5 participants last post by  michaelkitko 
#1 ·
Hey guys, I was just looking through some 140 pics and I had found one that had the 3/4" spindles running the 18x8.50-8 V61's. I am wondering if the front rims are custom built or are they off another machine? Looks cool and may go that way on a future project. Thanks!
 
#3 ·
Another option may be to put a later 140 axle with 1" Spindles in the earlier tractor. Not sure if it fits or not?

Or even have the 3/4" axle drilled for 1" if there is enough meat.
 
#4 ·
If I have another 140, without power steering, I will either fabricate a power steering system for it, or install tri-ribs. For extended use, especially use with heavy weight up front, or mowing in heavy going, other tires wore out my arms. So I have tractors with power steering.

But that is just me.
 
#5 ·
Just a late reply...the later model 140 axle will fit. I did that conversion on my 69 140.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top