Weekend Freedom Machines banner

112 no spark

2K views 9 replies 6 participants last post by  KB 
#1 ·
i got a 112 im working on.engine K241AQS seems to have no spark.i haven't pulled the points yet.but Im betting there bad.also looks to me that the coil is original.I see deere wants 80.00 for a new coil.i was reading another post where someone said something about a napa coil.has anyone used these??and what is the part number.thanks
 
#2 ·
I have a Napa coil on my 120 (don't know the part number) but would for the minimal cost difference consider the "clone coil" from kirkengines.com
 
#5 ·
I found this old post:

Bruce Mahr

Junior MemberUsername: jdmartian
Join DateJul 2008Posts12Thanks0Thanked 0 Times in 0 Posts

Bob: If you go to NAPA and get a IC14 or in the cheaper line, an IC14SB coil, they have a built in resistor and are 12 volt and will be a little cheaper than one from Deere. It is the exact same coil. I've been using them for years.

Bruce Mahr​


 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top