It's a good idea, and pretty much standard practice, to check a head for flatness before replacing a head gasket. I believe the spec is 0.003". Also,...
Later version deck should match up with your 318. 318 deck should have spring pins mounted on draft arms. I believe most parts will interchange also!...
Unless it's been repowered with ???, if it's got a Kohler engine, it's the early closed frame version, it it's got an Onan, it's the later open frame...
WHICH 316 are you looking at? There's an early 316, '75-'77, which is closed frame and few parts will interchange, and a later 316, '84-'92, which is...
Brett, Make sure the black knob below the center of the seat is fully CCW. This is your free wheeling control...CW, free wheel, CCW drive. Knob could...
Can't help on pulleys bore sizes, but JD belts do last longer. The reason for that is because they fir the v-groove in the pulley correctly! JD uses...
Where does wire go/connect to? If you have wire strippers, you could use those to "measure" the existing wire size. Place strippers on bare wire. You...
Tim, Once you get the collar off, you'll see the locking feature. The bearing has a male shoulder sticking out that is eccentric to the bearing bore...
Checking coil: I "kinda" know how, but I don't have the EXACT specs for the K321. The only numbers I have are for the coil on a 317. Plugs and points...
A new condenser is a good place to start. Another possibility is carbon in cylinder. Run SeaFoam for a bit and see if it changes. Another possibility...
Thanks Chuck. I've done some investigating/research into magnetism and amperage, and after reading about possibly 6 or 8 different "laws" that apply,...
Henry, The number of turns is rather irrelevant. You're looking for 4 ohms resistance of the total number of windings. Each wire gauge has a specific...
Turn engine over so muffler is sticking straight up. Spray penetrating oil...Kroil recommended, PB Blaster may work...wait an hour, spray, wait. Put...
Find latest posts