Got my parts in today and got back to work on it. Pulled the heads and was surprised how clean it was inside. Happy to see it has standard pistons and not bored oversize. Need new head bolts because the old ones are a bit rusty and just need replaced anyway. Starter is not engaging properly and just does not feel right so gonna pull the brand new one off my 316 and see if it is better before I put it completely back together. The starter side cylinder wall did have a little more junk and rust in it but a glaze breaker took care of that. Just need to swap points & condenser and assemble plug wires and hook up temporary fuel system until I can get all the fuel system replaced.