Weekend Freedom Machines banner
snowblower
1-19 of 19 Results
  1. Introductions
    Hello, I have a 2006 (I think) 155c and am looking to pick up a used snowblower attachment for my tractor. Could use some help identifying what used units I should be looking at?
  2. Want To Buy
    I am looking for the drive shaft of a 50 / 47' blower that attaches to a john Deere 400. The part # is AM36610 (see picture) I bought a JD400 with a blower but the seller didn't tell me that the drive shaft was the wrong one... If you any place where I could find this part (e.g. salvage yards)...
  3. FOR SALE
    Going to sell the 37a blower. PO used it, tines definately show it. I haven't ran it. Asking 150. I have the lift on the tractor if you want to talk about that. Rear weights m11028 120/pr. West point Indiana thanks.
  4. John Deere and Allied Attachments
    I wanted to share my restoration with everyone of the 49 snowblower I got in December. I acquired this snowblower along with a 318 from my brother-inlaw, who acquired it when he bought his house in Vermont. He used it up until about 2 years ago, when he couldn't get the 318 to stay running...
  5. John Deere Lawn Tractors & Late Garden Tractors
    Hi all, I have owned this John Deere 165 hydro-static drive lawn tractor for over a year now. I have used it allot and put a fair amount of work into it. The friend who recommended me getting it has a larger more useful tractor for sale I want but sadly its not a John Deere. The 165 has ran...
  6. FOR SALE
    I have a nice Snowblower, Cab, 2 sets of weights and 2 sets of chains. Asking $500 for the blower, $500 for the cab, $50 for each set of weights, and $50 for each set of chains. $1000 takes all real fast. If you buy all I'll throw in a real old, beat up, bent, cutting edge welded on, front...
  7. FOR SALE
    $1500. Starts nice. Runs pretty good, little smoke on start up, but none after that. Could use a little tuning, but I'm slowly getting there. Bracket that holds gearbox on deck is broken, needs replaced. I think the driveshaft is a bit out of balance that caused that. All else is good on...
  8. FOR SALE
    Location Kansas City Missouri p.m. with a phone # to start conversation I am going to part with one of my beloved JD 430 garden tractors to help with my business. I need to generate some money to put into my small business, so one of my machines will have to find a new home. I will sell one...
  9. John Deere and Allied Attachments
    I am running a 47" snowblower on a 430 garden tractor. After several seconds of blowing snow, the auger and paddles lock up, and the front PTO makes a horrendous clattering sound while trying to turn the blower shaft (which is locked up tight). After I clear the snow from the blower and chute...
  10. FOR SALE
    1978 316 Kohler. Engine was rebuilt 5-6 years ago. Little use since. I rebuilt mule drive a while back. Has old style JD hubcaps on front. With deck $850 obo I moved to location with a steep driveway. Chains were scratching up drive. That & shoulder surgeries had me move into 4wd machine with...
  11. Hydrostatic Drive Tractors
    Hi all - running a snowblower on the front of my 317, but the hydraulic lift only goes in one direction. If the hoses are connected one way the snowblower goes all the way down, if the other way all the way up. The lever does nothing. I've not worked on the hydraulics at all on this tractor...
  12. Round Fendered Tractors
    Hi everybody. I've been following for a while but haven't done my introduction yet. I'll get to that one day soon. However, right now I have a question I hope someone can answer. I have a '66 110 and have been wanting to get a model 36 snow thrower for it. Recently I came across a nice deal...
  13. FOR SALE
    It's time to thin the herd. I have for sale the following: 318 is a 1983 with 922 hours and includes 50 inch mower deck, power flow bagger, snow thrower, wheel weights, model 10 lawn/dump cart. Next are 2 – 140s. Both are 1968 models. One is good running and the other is my parts tractor...
  14. Hydrostatic Drive Tractors
    Hello, First post here. I just purchased my first JD, a 314 that had a rebuilt (original) engine. I have run it a number of times with no issues. This morning I was snowblowing (model 49) without issue. My neighbor came by to admire the machine, I turned the tractor off for 5, then I started it...
  15. Gear Drive Tractors
    1973 John Deere 112 Electric Lift, Buccateer, Blade, Blower, What is is worth?? I am the second owner of this 112. This tractor is in very nice condition, and runs and operates flawlessly. I am pretty sure that machine has had a light refurbishing about 10-15 years ago. This 112 has a 12 hp...
  16. John Deere and Allied Attachments
    Can anyone tell me if they have been able to replace the bearing on the tensioner sprocket on a 49 snow blower? JD # for assembly is AM31238/AM108291. Bearing is ND #3203AC, which seems to be readily available. Bearing is a lot cheaper than the assembly if it can be replaced. Thanks for the...
  17. FOR SALE
    Up for sale is a very nice Deere 38 snowblower. Included is the left and right braces, mule drive, spring tensioner for mule, installation manual, chute turn rod, and lift rod (not shown). This blower has not been used on gravel driveways. I've used this for several years mounted on a Deere...
  18. Hydrostatic Drive Tractors
    Hi guys, I have a '73 140 H3 I'm fixing up....got the 38" mower, and tiller, and thinking about putting a 2 stage snowblower on it.....either a Berco or the 44" JD.....both belted. How does one do this? I see them on youtube but they never show the hook up. If I can make this work I...
  19. John Deere and Allied Attachments
    I have an opportunity to purchase a Deere 47 blower, the old heavy version, for my 322. I was wondering if anything had any tips or tricks for attaching. I have never attached one or anything to the front of my tractor before. I understand the basic concept, but with a beast like this I doubt...
1-19 of 19 Results
Top