Weekend Freedom Machines banner
1 - 5 of 5 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
I just bought a '66 110 that is going to replace my '67 112H and I am in the process of swapping over the good parts to make one good tractor before I sell the 112. I had to buy a new pulley for the throwout assembly because the 112 has the double belt setup and the 110 is a single belt. The 112 double pulley is an actual v-groove idler, and the 110 pulley AM30191 is just a flat idler. Is this right? It rides on the vee side of the belt so I would think it should have been a grooved pulley.
 

·
Registered
Joined
·
59 Posts
Discussion Starter · #4 ·
thanks... now it's time to swap the rest of the parts over if I ever get time. I also need to look at the carb on the 110 - only wants to run with some choke, and it seems like anything above 1/2 throttle is wide open. I'm hoping it's just a leak around the carb gasket...
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top