While there is a thread going on this item, allow me to pose a couple of commonly asked questions concerning the heavy duty air cleaner kit. Are the round "bell" and rubber nipple still available through mother Deere using 317-400 part numbers? Also does anyone have the pattern or exact measurements needed for installation on the 110/112 hood support. As soon as I can get mine powder coated I will be ready to install on my '73 110.
112 air cleaner ??????
I have a 97 345 with the 18hp in it. Have always wanted a 54" deck (have the 48) to get the lawn cut faster. Might have found one I can trade up to get.
In the past I have also run my powerflow bagger, but this year due to the dry conditions(but primarily due to the fact my buddy that would take the clippings for his animals is no longer living near by) I have not been bagging.
Is the 54 about all the engine can handle? Will the powerflow push it over the edge? I like to cut at a pretty good pace.
In the past I have also run my powerflow bagger, but this year due to the dry conditions(but primarily due to the fact my buddy that would take the clippings for his animals is no longer living near by) I have not been bagging.
Is the 54 about all the engine can handle? Will the powerflow push it over the edge? I like to cut at a pretty good pace.
1 - 1 of 19 Posts
1 - 1 of 19 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Weekend Freedom Machines
A forum community dedicated to Vintage John Deere Tractors owners and enthusiasts. Come join the discussion about classic restorations, references, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
army
213 Replies
TempletonJDguy
182 Replies
tmac58star
151 Replies
Recommended Communities
