Weekend Freedom Machines banner
1 - 4 of 4 Posts

· Registered
665 Posts
Discussion Starter · #1 ·
I stopped at a machine shop last night to see what it would cost to have them bore and put bushings in my worn front axle spindle holes. The guy said he did not have the equipment to bore a hole that small, but it would be expensive just in set up time. Those of you who have put bushings in your front axle to get back to a 1" bore, how was it done and what did it cost you?

Thanks for the input!

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.