Weekend Freedom Machines banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
  • Serial # < 30,000
  • Rear wheel weights
  • Complete, working model 33 tiller
  • 46” mower deck and mule drive
  • 3-point hitch with
    • New lift cylinder and top link
    • Boom pole
    • Sleeve hitch
    • Draw bar
    • 60” Brinly blade
  • Dual lift/dump front attachment mount
    • Lift cylinder failed ($150 on amazon - $250 off price if you replace)
    • 36” front (lift and dump) scoop
    • 48” front blade (it has sides on each end so it may be a snow plow)
  • Unknown front attachment mount (may be for front weights)

It has been stored in my shop since I purchased it two years ago, it starts and runs well. I used it this year to till my garden and drag a couple of Cedar trees we cut down out of the woods. The v-twin leaves a couple of oil drops on my shop floor. I understand it is not uncommon for a v-twin sump or rear seal to leak. It looks like it would not be hard to pull the engine; I just have not gotten around to it and the spots are not large enough to motivate me to do so.

I am located in Nacogdoches, Texas and will consider delivery for additional cost depending on your location. Please send me a private message (PM) if you are interested.
 

Attachments

1 - 1 of 1 Posts
Top