[wausau]

Is anyone familar with the bearing, p/n AM30774,
on the inside of the Hydro Control Lever. My 73 140H3 has a plastic bushing installed in the support bracket for the steering column.The part shown in the IPC shows a bearing bracket installed with bolts.

 

[mikeduwe]

10 is plastic split bushing that goes into the side of the pedistal. 2 is the "bearing" but I cannot recall if there are actually balls or rollers or just a sleeve that rotates.

Its about $12 so if if you dont think its original, not too expensive to the right one. Might as well get a new number 10 as well. I looked quite a bit online for that size and deere was the only one that had one.