[mark_morin]

Hello gentlemen do any of you have a recommendation on a pto pump for a splutter or loader on a 400 and can one still find a rear pto kit

Thanks Mark

 

[mark_morin]

thanks for the info

does any one know what the keyed shaft on the upper right side of a 77 400 rear end is for did jd ever run anything off this.

also what is that the lift capacity of the stock 3 pt hitch and is there a easy way to get down pressure from it

thanks

 

[mark_morin]

what should one expect to pay for good condition used 26 x12x12 bar tires on rims loaded calcium.

calcium or wheel weights whats better.

 

[mark_morin]

Hello does anyone know what the small keyed shaft on the upper side of a 77 400 rear end is for .I just finished restoring my 400 and noticed it when the tank was off.

Also does anyone have a rear weight recommended for snow plowing.

Thanks and happy holidays Mark

 

[mark_morin]

good afternoon can any one tell me the psi and gpm of a 77' 400 stock hydro sys.i saw info on 318 and 420 but no 400.

why does the jd loader for a 455 only lift 350 is it the pump or cylinder size.has any one modified a 40 loader for a 400

thanks

 

[mark_morin]

Thanks Jr.
Right now I have the 15 moldboard plow on the 3pt and a 4'
Length of railroad track approximately 200 lb total.
I will try to take a photo of that shaft to see if anyone can help.
Thanks Mark.

 

[mark_morin]

Thanks David
Great idea on the wheel weights and thanks for Taking the time to post photos for me.
I also found out the shaft on the differential is the shifter shaft it is shown in my service manual.
Now if someone can send some snow I'd appreciate it.

Thanks all and happy holidays
Mark