Weekend Freedom Machines banner
Status
Not open for further replies.

2010 Open Forum ARCHIVE

263K views 4K replies 644 participants last post by  Bweaver7734 
Chas - good luck with the 212. You'll get a lot of seat time if you plan on doing a 3/4 mile driveway with a 212 blower

Spend some time checking the variator - make sure it speeds up & slows down the tractor. they can get stuck if the tractor has been sitting. I've had my 216 for a year now and have had to replace various bearings - none difficult and none that make me regret owning it. I'd also plan on changing the belts after you get it.
 
Adam,
I've never really measured but I'd guess my 31 is going 5-6". I also have to admit that I've never played too much with the depth setting or anything else to see if I can get it down more. I do think my manual tiller gets down deeper, but it's not as fun


the 31 is the right tiller for a 214. I've seen some 30-hydr tillers advertised for the 200 series, but I'm not sure if it was a factory setup, or a custom thing.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top