Weekend Freedom Machines banner
1 - 10 of 10 Posts

·
Registered
Joined
·
159 Posts
Discussion Starter · #1 ·
I'm looking for the motor shaft and tine shaft from a 30 tiller, its a long shot, but maybe someone's motor went bad and the shaft is good. Thanks
 

·
Registered
Joined
·
159 Posts
Discussion Starter · #3 ·
Dale... I called your phone and the voicemail was full. I'll try to text you. My cell 724 350 5891 call or text me. Thanks
 

·
Registered
Joined
·
3,271 Posts
Can you drill both out and put a grade 8 bolt in it?
 

·
Registered
Joined
·
159 Posts
Discussion Starter · #5 ·
That's what I'm thinking, the hydraulic shop its at is also a good machine shop, so that's plan B!
 

·
Registered
Joined
·
159 Posts
Discussion Starter · #6 ·
Dale, I'm going to be calling you again to buy a tiller from you. Got word from the hydro shop today both the pump and motor are scrap. I'd say I have a parts tiller, but there isn't much very good on it anymore, tines/tine shaft, pump and motor are all junk. Pump is salvageable for $325...
 

·
Registered
Joined
·
33 Posts
ok, I am getting ready to set up my 420 with a 30 hydraulic tiller. I am looking for a 3 point bracket for my tillers. I heard their is someone that is building them to sell. if you have any information on 3 point brackets for the 30 hyd. tiller, would like the information on how I can get a couple. I am also looking for another pump with double pulleys and rear mounting bracket, and another pump mounting bracket, just the bracket for rear pto set up.
later,
Dale
 

·
Registered
Joined
·
3,271 Posts
  • Like
Reactions: 30nate

·
Registered
Joined
·
269 Posts
I'm the guy your looking for if you want a 3 point bracket for a 30 hydro tiller. I'll send you a pm also. Travis thanks for finding and bumping my thread!
 

·
Registered
Joined
·
3,271 Posts
Your welcome. If you are willing to build something that we don't have to re-engineer then that is great for the rest of us too. Everyone wins.
 
1 - 10 of 10 Posts
Top