Weekend Freedom Machines banner
1 - 7 of 7 Posts

· Registered
Joined
·
186 Posts
Discussion Starter · #1 ·
I can't seem to get my 316 Kohler to take hydraulic fluid. Is the spot on the photo marked with a yellow circle the correct place? The fluid will run out the top of the tube before it shows in the sight tube?

Help!

Thanks,

Joe

 

· Registered
Joined
·
186 Posts
Discussion Starter · #5 ·
Vinnie,

Nothing on the top (or bottom) of the sight tube. Must be missing, I'll check with JD Parts.

I did get it to the proper level removing the top line, but it was slow...

Thanks all,

Joe
 

· Registered
Joined
·
913 Posts
Yup I would say that is the issue. Might have to be ordered, I had to for my 314, wasn't much if I remember right. I found that after I got it to correct level after running a bit it was low again after sitting a while. So check it again just to be sure.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top