You may have a carburator float problem or dirt in the carburator since it seems to be position sensitive
318 cuts out and dies
Hi guys,
I have a 318 with a P218 engine, after running for about 20-30 minutes, if I go downhill with the mower pto on the engine with start to cut out bad and sometimes die.... it only does it warm, pto on, and pointing downhill (sometimes turning hard and fast)... fuel lines are replaced, pto is new, seat switch is bypassed, pto is direct wired to switch and battery, and I have tried a jumper wire to the coil to bypass the TDM, still does it... also the cylinder head temp (according to my laser temp gun) is at about 310F.. not sure if that is a problem
I have a 318 with a P218 engine, after running for about 20-30 minutes, if I go downhill with the mower pto on the engine with start to cut out bad and sometimes die.... it only does it warm, pto on, and pointing downhill (sometimes turning hard and fast)... fuel lines are replaced, pto is new, seat switch is bypassed, pto is direct wired to switch and battery, and I have tried a jumper wire to the coil to bypass the TDM, still does it... also the cylinder head temp (according to my laser temp gun) is at about 310F.. not sure if that is a problem
1 - 1 of 4 Posts
1 - 1 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Weekend Freedom Machines
A forum community dedicated to Vintage John Deere Tractors owners and enthusiasts. Come join the discussion about classic restorations, references, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
tmac58star
177 Replies
army
161 Replies
TempletonJDguy
153 Replies
Recommended Communities
