Weekend Freedom Machines banner
1 - 2 of 2 Posts

· Registered
27 Posts
Discussion Starter · #1 ·
The clutch on my new 430 wont close to the .018 air gap when I get close the compression ring is so tight the unit wont rotate. When checking every thing on the bench I get a gap of .110 when placing a straight edge on the shaft bearing between it and the contact surface, and I get a gap of .075 when I place both contact surfaces together with out springs or compression ring. Both of these seam large to me. Where and what do I do know, I don't want to start moving things till I know how and when Thanks Brian
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.