[Gregs Toys]

Has anybody designed a support stand to keep the 48" 3 point. tiller from tipping forward/rearward?
Thanks,
Greg J.

 

[ddogg]

Greg, I just use a Harbor Freight furniture dolly with some 4x4 blocking.

 

[coalminer16]

On my 3 point mount for my JD 30 hydro tiller I ground down a 2x4 and since it has 3 holes in the 3 point mount I put pins into the 2x4 on the top and bottom holes. Works good for that at least and mine also cheaply work for the 48.

 

[grandpa_dudee]

Hi Greg,
I also use a furniture dolly from Menards, but I cut out a "bed" for mine out of 3/4" plywood. I cut it with an extention in the rear to support an old jack stand for the rear of the tiller to rest. When I bought my 430 the tiller was mounted on the tractor so I when I removed it I had a very humbling experience with the tiller rolling. Fortunately I still have all my toes! I learned real fast about blocking the rear of the tiller.

 

[farm_boy]

I just use the leveling door on the back, make sure it is chained open a bit then when you pull the top link it rocks back onto the door. Then remove the lower links and the shaft.

 

[Hammerdown-7]

Hello Greg
It would be A great idea if someone made up some Tiller stand bracket's to keep the tiller perfectly level and allow an easy un-bolt and bolt up of it. I may be inclined to make something up in the very near Future as mine is Not a three point arrangement and it can be a bit of a challenge to get it mounted on the mounting point's of my 318 Tractor. Regards, Kurt