Weekend Freedom Machines banner
1 - 1 of 1 Posts

· Registered
629 Posts
Discussion Starter · #1 ·
I'm wondering if anyone else has mounted a 50 snowblower to a 430? I was under the impression it would mount right up after welding the bar across the bottom mounting pins. After installing the frame and pto extension, the driveline was about two inches short. I ended up taking the drive setup and pto extension off of the gearbox and used a mower driveshaft that I cut down by an inch. I'm curious what others have done?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.