Weekend Freedom Machines banner
1 - 1 of 1 Posts

· Registered
134 Posts
Discussion Starter · #1 ·
Iam putting a 140 deck on a 316, I have the correct draft arms to switch it over but it seems Like I have to hog the deck bracket holes out to accept the 316 draft bars. It seems like the deck brackets will be ok to handle the bigger shaft but I do have a concern if the deck brackets can handle it in the long run. Any feedback on this would be appreciated.
Lou in ct.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.