[jmiller1007]

I just replaced mine. It’s not that bad. You just remove the radiator, shroud and drive shaft isolator. It takes a few hours. But since you have it out you might as well clean the radiator really well and degrease the engine. I enjoyed it.


Sent from my iPhone using Tapatalk

 

[jmiller1007]

Actually you asked if anyone has experience using industrial half inch link belt, and no one responded. I have a feeling most on here would rather put a john deere belt one on, especially if your going through all that work of removing and replacing the radiator.

I absolutely prefer John Deere belts over a link belt. As a Refrigeration/ Boiler Mechanic I can say link belts don’t do a great job. They’re okay if you’re in a real pinch and it’s a very temporary replacement. But you won’t get proper tension and I doubt you’ll get a proper fit so you’ll likely be causing improper wear and grooves on your pulleys making new problems.


Sent from my iPhone using Tapatalk