[Jbrown9709]

Hi,

This is my first post. I picked up a non-running 322 for $400 this weekend, and with nothing more than a battery and hydro fluid change/fill, have a well operating machine. Unfortunately, a deck was not included. I've bought a 50 inch deck from a 318 off of flea-bay, but for some reason the seller has removed the draft arms. They look very simple to fabricate, and I have a shop full of metal fab equipment. I was hoping someone could post the dimensions (particularly hole spacing between holes labeled as A, B, and C, as well as the distance the bend offsets (appears to be about an inch) Thanks for your help, Jeff

 

[knottyrope]

Same happened to me and I ended up buying them off evilbay.

 

[scubaprokid]

Jeff,

Check the classifieds here on WFM. Bill Less just listed some arms off a 48” deck which may just work for your 50" deck.

 

[Bjones809]

Jeff,
here is the link to the one that Bill has listed that Tim was talking about.

http://www.wfmachines.com/discus/messages/174/31506.html?1249414691

 

[scottw]

A to B = 3 5/8" centerline to centerline
A to C = 13 7/16" centerline to centerline

Part #8 is 3/4" diameter
Part #12 is 3/8" diameter

Here you are.(These are approx dimensions measured with deck installed) I will say I agree that it would be easier to buy some, but hey, to each his own. Good luck,

 

[Jbrown9709]

Thanks everybody. I did end up buying Bill's arms.