Weekend Freedom Machines banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,204 Posts
I went to local hardware store and bought two different sizes. Large ones 2 per hole one above and one below and then smaller, I think it took 3 per hole to equal the plate thickness. For the smaller ones the out side dimension was too big. I put them on a bolt which I chucked in a drill and ran against belt sander to get the size I needed.
 

·
Registered
Joined
·
279 Posts
I used a fiber like gasket paper cut out a bunch of about 1" squares and the ran them in a drill against a sander until they just slipped in the bracket. Then a bigger one above and below.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top