Joined
·
2,519 Posts
I redo my seats with the jd vinyl/foam kit, 80$. Reuse the seat pan with Deere logo and sometimes dealer tag. Reuse the seat trim strip which is already perfectly formed and super tight. They look mint 👍🏻
Posts by TempletonJDguy
1 - 9 of 34 Posts
Joined
·
2,519 Posts
Yes I believe so, it’s a genuine jd part. I get mine from the green store I believe. I have to run out for a bit but I can look it up later if you need me too.
Joined
·
2,519 Posts
The kit comes with the brass grommets. Installing them takes a bit of practice. I opt to leave them out. Heres the part number off jd parts.
![Motor vehicle Cabinetry Automotive design Car Chair]()
![Vehicle Green Tire Automotive tire Hood]()
Joined
·
2,519 Posts
For the whole seat right? Not the kit,…
Joined
·
2,519 Posts
They were available! Im not finding it either now 
Joined
·
2,519 Posts
Yup v Bosch has it right, thank you
Joined
·
2,519 Posts
I use the adhesive, but I also use it for a lot of other stuff so it’s good to have. I reuse the old seat trim. It’s much tighter and already formed to the contour so it works much better and it doesn’t even need a clip but I use it and the clip fits much better on the old trim.
Joined
·
2,519 Posts
Re using the old edging was actually a lot easier than I thought it would be, in fact it was silly easy. Once you push it on it stays put 👍🏻
Joined
·
2,519 Posts
Interesting,… I didn’t think there was metal in the new trim. If there is though that’s a great trick 👍🏻
1 - 9 of 34 Posts
