[bulliedawg]

The area where the ignition switch and light switch are located on my 110 (below the dashboard where the throttle and choke are located) gets extremely hot when I run my tractor. It gets so hot that it's uncomfortable to touch. I am wondering if this is normal, or if it's something I should worry about. I am wondering perhaps if I need a new regulator/rectifier.

Thanks!

 

[kilmer31]

Is there a way to adjust the mowing hight on a 180 other than the adjusting lever?

 

[T-Mo]

Lee,
I do know there are adjustments you can make for leveling. Try this link for a service manual:

Service Manual

 

[kilmer31]

Thanks Terry, I'll check it out.

 

[kilmer31]

I need some advise. I have a 46" deck with standard blades and a power-flow unit. It works ok but I'm thinking that hi-lift blades might work better. JD says that only one blade is offered for my mower deck. Any thoughts? Thanks in advance. Lee.

 

[tim_semenuk]

What do you feel it's not working the best that it can with the normal blades?

 

[kilmer31]

Tim,

I just wondered if I would get better leaf pick up with a high-lift blade. Lee.

 

[mark65]

Part number M127466 is a higher lift blade for the 46 mower deck, but if your impeller is good in your powerflow, it should work well without the blades.

 

[kilmer31]

Thanks to all. I think I will try the higher lift blade next time I purchase new ones. I have two sets of the standard blades already. Thanks again. Lee.