Weekend Freedom Machines banner

How to stop the engine ?!

1899 Views 13 Replies 5 Participants Last post by  jolanda
Another stupid question from Germany ;-)

The pre owner of my JD 100 unconnected allot of wires and little pluggers. The safety switch for the PTO clutch is unmounted and short-circuited - but thats another story.

My problem is about stopping the engine. I think the regular process to stop the engine / ignition is done by turning the key to position "off". But my engine is still running in this position. I might found the problem by testing the wires coming from the ignition lock with my voltmeter. There is one unconnected yellow wire. My voltmeter indicates connectivity to the minus pol (ground) in key position "off". It has no connection to the minus pol in position "run" and "start".

I am assuming that this unplugged yellow wire is probably the right one to stop the ignition / engine. Right?

But were shall this cable be connected to?

Again, sorry for the stupid question but I don´t
have a wiring diagram for the JD 100.

Best from Germany,
1 - 1 of 14 Posts
If Roger posted a response earlier in this thread, I wold be interested to know what happen to it also.
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.