[tom_schaech]

All:

I have a 46 inch deck on a 265 tractor that was brought to me in pieces. I've searched high and low for a complete diagram or picture that shows the stack pulley and idlers in their proper places, with the springs attached so I may put this back together. JD dealer was no help. Anyone out there have such an item or own one that they would be kind enough to post some photos for me?

Thanks!

Tom

 

[T-Mo]

Tom,
There is only a couple of members here who have the newer 200 series GTs. Maybe even less with the 46 deck. With that in mind, I copied the image from JD Parts. Maybe it will give you a start.

 

[fred]

Tom;
I sent you an e-mail with some photos of my 46 deck.
I remove belts and springs when I store it for the winter.
I can put them back on for a photo if you need it.
Fred

 

[tom_schaech]

Fred:

THANK YOU!!! I'll let you know when I get back into the shop...I'm away at work until Saturday...I think this is exactly what I was looking for!!!

Thanks again!

Tom

 

[tom_schaech]

Fred:

THANKS---pics were right on! Too bad JD parts doesn't use a concept like that to help their assemblies!

I really appreciate your help!

Tom

 

[fred]

Tom:
Glad to hear that it worked for you. I used the image Terry posted when I rebuilt my deck two years ago. And today, my decks go into storage until spring.
Fred

 

[oleboy]

I'm in the midst of restoring my 140/H1 and in the process, going through the engine while it's out. I didn't need to take off the exhaust elbow. Nonetheless it's off after some persuasion. The threads are fine, but the non-threaded portion got oval shaped from the pipe wrench. At this point I'm not sure I can reuse it or not.

For the sake of knowing ahead of time, are there any suppliers of new exhaust elbows, or am I destined to buy a used one? Or using the one I have?

I've seen where others have used plumbing fittings to build one up. I'd rather not. It's just not right. Heck, worse case I'll fabricate my own if I have too.

What's my best option?
Dom

 

[woodpecker41]

Dominico I believe you can get new ones. Www.jdparts.com and www.partstree.com might be places to look. You are in the wrong forum as the 140 isn't a gear drive. Maybe Terry will move this for you. Roger