Weekend Freedom Machines banner

1 - 12 of 12 Posts

·
Registered
Joined
·
90 Posts
Discussion Starter #1
Does anyone know the party number for the rear lift linkage for under the tractor on the later model square fender or 200 series tractor?
 

·
Registered
Joined
·
90 Posts
Discussion Starter #3
Does anyone know off hand what size bolts and spacers I need for the bottom of the frame where the sleeve hitch would "hook" to? TIA
 

·
Registered
Joined
·
3,216 Posts
If you use the link to the parts catalog provided by Steven, you need no. 12, 13, and 14. 12 is a 1/2x 1-1/2" bolt, ya also need a lock washer and a 1/2" nut. Now for the bad part 13 is a short piece of pipe, the width and diameter need to match the notch in the sleeve hitch.
 

·
Registered
Joined
·
658 Posts

·
Registered
Joined
·
90 Posts
Discussion Starter #6
Thanks guys. I'm still looking for the rear lift linkage for under the tractor if anyone has one they'd part with
 

·
Registered
Joined
·
90 Posts
Discussion Starter #7
Yeah those spacers are hard to find. I ended up cutting some on the lathe. Mounted now, just need to figure out a lift rod. Thinking about a hydraulic lift setup and just mounting the ram directly to the sleeve hitch. That way I can raise and lower the plow and back blade separately. What are your thoughts on this
 

Attachments

1 - 12 of 12 Posts
Top