Weekend Freedom Machines banner
1 - 6 of 6 Posts

·
Banned
Joined
·
3 Posts
Discussion Starter · #1 ·
I just got a Model 56 from my grandpa and it isn't running. I pulled off the carburetor to see if it was gummed up and in my haste didn't take note of how the throttle linkage and the linkage for the governor was attached to the carburetor. Would any one happen to have a picture that could help me out with this that would be wonderful!

Thanks so much in advance hope I can get this thing running before snow falls so that I can get my yard mowed!!
 

·
Registered
Joined
·
308 Posts
Can I send you a (Adobe) copy of the repair manual with the detail you need? Its 2,545KB in size.

Unfortunately, I cannot copy just a diagram or the respective page.

In essence, from the governor arm a solid linkage goes to the throttle butterfly on the carburetor. From the governor arm (the lower of the two linkages) a spring, connects to a linkage which goes to the arm opposite to where the throttle cable connects on the plate on top of the carb.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top