Weekend Freedom Machines banner
1 - 3 of 3 Posts

·
Registered
Joined
·
299 Posts
Discussion Starter · #1 ·
I have a good friend that has recently purchased a R72, the mower runs great but yesterday he was mowing, which it was doing fine, then when he was finished, he backed the mower up to turn and when he put it back in gear to go forward, nothing, in any gear. He said if you keep at it it will jerk and move a little but pretty much its dead in the water, still goes fine in reverse.
 

·
Banned
Joined
·
150 Posts
i cant remember for sure,but i think there are bolts that hold the hubs to the rear axle.if one of those broke,or sheared,that could cause your problem.also,check the belt.i had one start to shred on my 55(similar setup)and it did the same,for whatever reason.hope this helps.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top