Weekend Freedom Machines banner

1 - 2 of 2 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
I took off my rotary deck off over the winter and did a complete under and over paint job. The new belt is also installed.

I have the rotary under the tractor and I have followed each step of the Operator's manual for "installing the mower." I get within an 1/8" of getting both J pins fastened to the draft bar. It seems that I can get one fastened, but not the other. Is there a trick, or a secret code to getting the deck fully installed. Once this step is completed, I only need to slip the mover drive belt over the mower drive pulley.

If anyone has a tip for me, I sure would appreciate it!

Thanks!
 

·
Registered
Joined
·
1,507 Posts
Push the deck back and up. Should create enough room at the front for the draft plate to snap into place.

Dom
 
1 - 2 of 2 Posts
Top