[cd202]

Anyone know where I can procure some of those spiral rivets that are used to attach serial tags.

 

[funnydirt14]

John Deere..............

 

[mrbacklash]

how did you remove them it is pretty tight to get a punch on the back side of them. Do you have a part number for the rivets, if it isnt in jdparts it doesnt exist for my dealer

 

[mrbacklash]

just found them on mcmaster look up screw nails for metal

 

[woodpecker41]

If you are good with a small vice grips you can remove the rivets by turning them CCW and pulling out at the same time. They have a spiral on them that helps hold them on. Don't try this with one of the vice grips copies around. Roger

 

[cd202]

Or when you completely disassemble for restore you just pound them out

 

[cd202]

My JD guy can't find the number either

 

[markia]

Try 33H44, That is the rivet for serial number plates for the John deere tractors. Last I knew they were still available from Deere.

 

[markia]

Made a mistake, part number is 37H44. Hope this helps..

 

[KB]

they are still available, $0.33 at my dealer

 

[herg]

Colton...
I have a set if you are still needing some.

 

[cd202]

I told my dealer to round me up a pack full

 

[mrbacklash]

picked up 2 this afternoon and they are not the correct size not sure if the part number is wrong or the part is wrong but they are too large to even begin to fit though the plate or the dash, the unthreaded portion will not fit in the hole