[ibleedjdgreen]

I have these parts left over. I can't figure out where they were supposed to go. Can someone help me out?

 

[mcain]

Look like mower rear deck roller braces.

 

[smalljob]

They are used to mount the dash to the pedestal I am guessing the only thing holding yours on are the two front bolts. The go on either side and mount to the dash near the choke and throttle levers. Let me know if you are still stumped and I will get a photo.

 

[lisle]

I thought they were the brackets that hold the pedestal to the frame ? But maybe I`m getting senile.

 

[ibleedjdgreen]

Thanks for the help everyone! I have another round fender that I have been using as my "prototype" for my assembly and these brackets are hidden very well. But they do go under the pedestal.

 

[herg]

Since the gallery is down... does anyone have a picture of this part installed?

 

[smalljob]

Mike I sent you a photo to your email address. Could not get it small enough for WFM...

 

[herg]

Thanks for the picture Bill!