Saw this carb for sale. Seller says it comes off a Tecumseh HSK70 H70 engine (1" shaft dia). It comes from Ariens ST724 snowblower.
Will it fit a Vh70 or V60? Thanks I am guessing it will not since I see the primer?
+++ jpeg +++ 185502 +++
I have put primer carbs on 2 of my 70's. alittle tempramental to start but run fine, one carb is off a 3.5hp and lacks top end power but for a cruiser it's fine. other is off a 6.5 and we use this one to mow with.this primer is on top and mine are on the side
The original carbs have 90 degree fuel inlet fitting facing towards spark plug. Snow blower engines have theirs going straight thru blower housing. You'll have to reuse your old choke shaft and return spring and then I think you should be good to go, I have two carbs from the same engine. E-mail me if you are interested.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to Vintage John Deere Tractors owners and enthusiasts. Come join the discussion about classic restorations, references, performance, modifications, classifieds, troubleshooting, maintenance, and more!