Weekend Freedom Machines banner

1 - 3 of 3 Posts

·
Registered
Joined
·
213 Posts
Discussion Starter · #1 ·
I need to replace the belt on an X758 power flow. At the impeller pulley there is large rod which acts as a belt guard. It doesn’t have an adjustment for allowing room to get the belt off. Do I need to remove the pulley from the impeller shaft? Any input appreciated.

Mike
 

·
Registered
Joined
·
213 Posts
Discussion Starter · #3 ·
Thank for your response and link. After a bit of head scratching I used an impact wrench and removed the impeller pulley. Replacement belt went on without any other issues.
 
1 - 3 of 3 Posts
Top